Care · in collaboration with THE HOOKAH

How to clean a hookah: what can get wet and what can't

Most of a hookah cleans up with water and a brush, but not all of it. See which parts can get wet and which must stay dry, with tips from the manufacturer THE HOOKAH for modular hookahs.

Why clean your hookah

After every session, smoke, molasses and small bits of tobacco stay behind in the water, the stem and the hose. If they sit there for days, the next session tastes like the last one and the water starts to smell.

The good news: most parts clean up with just water and a brush. But not every part is the same. Modern modular hookahs also have wood, leather or electronics, and those must not get wet. Tap a part on the drawing below to see how it is cleaned.

In collaboration withTHE HOOKAH
  • Can get wet
  • Careful
  • Keep dry

Cleaning step by step

This is the general order for most hookahs. Always check the manufacturer's instructions for your own hookah, especially if it has wood, leather or electronics.

  1. Let it cool

    Wait until the bowl, coals and tray have cooled down completely.

  2. Take it apart

    Remove the bowl, tray, hose and mouthpiece, then lift the stem out of the base.

  3. Base

    Pour out the water, rinse the base and clean it with a brush.

  4. Stem and downstem

    Rinse them with water and run a brush through until the water comes out clean.

  5. Bowl and tray

    Clear out the old tobacco and rinse the bowl and tray.

  6. Hose and mouthpiece

    Rinse a washable hose, and only wipe wood, leather and charging parts with a dry cloth.

  7. Dry

    Let everything dry completely before the next session or before charging.

Modular hookahs: electronics, wood and leather

One mouthpiece can be wood on the outside with a stainless steel tube inside. Another has a charging port in the same spot. Clean both based only on the material of the inner tube and you risk damaging the wood or the electronics.

THE HOOKAH, a hookah manufacturer and online shop from Eschenburg in Germany, shows this with two of its models.

THE HOOKAH · Eschenburg

Visit THE HOOKAH

DAYWALKER

Keep the electronics and ports dry

  • The stem and the mouthpiece light up, and each has its own micro-USB port.
  • Before cleaning, unplug both cables and put the parts on a dry surface.
  • Do not submerge the mouthpiece: the LED and the port must not get wet.
  • The molasses catcher above the stem collects dripping juice, but it does not seal the port against water.
  • Only charge a part that is completely dry. If water gets into a port, stop using that part.

TIGER WOOD

Each material needs its own care

  • The mouthpiece is wood on the outside and stainless steel inside. The wooden parts must stay dry.
  • The hose is silicone wrapped in genuine leather, so do not soak the whole hose.
  • The stem comes apart, the downstem has several parts and the diffuser at the bottom unscrews.
  • The glass base may only be rinsed with cold water, separately from the other parts.
  • Let the bowl and tray cool down before you take it apart.

DAYWALKER: the stem and the mouthpiece each have their own charging port. TIGER WOOD: the wood on the mouthpiece and the glass base need different care.

Before the first rinse

  • Look for charging ports, joints between materials and the points where each part comes apart.
  • Put the parts that cannot get wet aside first.
  • A hookah that comes apart does not mean every part can go in water.

Model tips: THE HOOKAH, based on the manufacturer's instructions. thehookah.de

Common mistakes

Washing the hookah while it is still hot. Hot glass can crack under cold water, and hot parts can burn you.

Soaking a hose that is not washable or that is wrapped in leather.

Charging a light-up part before it is completely dry.

Soap in a clay bowl: clay soaks up the smell, so the next session tastes like soap.

Putting it back together while the parts are still wet: water left in the stem and hose quickly starts to smell.

In short

Frequently asked questions

How often should you clean a hookah?

Change the water and rinse the base after every session. Clean the stem, downstem and a washable hose thoroughly on a regular basis, and at the latest when you notice an old taste or smell.

Can I wash a hookah with soap?

Water and a brush are usually enough for glass and metal. Do not wash a clay bowl with soap, because clay soaks up the smell. If you use a cleaning product, rinse everything well.

Can the hose go in water?

Only if it is washable, for example silicone. A classic hose and a hose wrapped in leather should not be soaked.

What if water gets into a charging port?

Do not charge or use that part, as THE HOOKAH advises for its LED models. The electronics housing is not meant to be opened.

Why can some glass bases only be rinsed with cold water?

Because the manufacturer specifies it for that base, for example THE HOOKAH for the TIGER WOOD base. Always follow the instructions for your own model.

More articles